THIS IS A WORK IN PROGRESS
RailCore II 300ZL 3D printer
The RailCore is a CoreXY-style printer which is a very accurate and fast. It uses a Bondtech extruder with an E3D V6 hotend, and extremely presice Misumi linear rails to guide movement on every axis. Currently, the nozzle is a 0.4mm abrasion-resistant nozzle that can be used with all filaments. This is a more advanced printer than the Prusa or Xinkebot, but don't worry, it's actually fairly easy to operate. It runs using RepRap firmware on a Duet Ethernet board.
Details about the using the Duet can be found here:
Most of this is extra background information. Homing and leveling are taken care of in the slicer (Simplify3D) beginning scripts so you should not need to do any preparation work. You should not need to do any calibration such as Bed Mesh creation or any other advanced operations. The bed should be level and very flat as is.
1. Turn on the RailCore using the switch at the bottom rear of the electronics box on the right side of the printer.
2. Watch the readout on the LED panel above the electronics box for the assigned IP address. If you forget it, you can always press the "console" button at the bottom of the screen. Note that you will get a warning about the heater being overpowered. It's OK to ignore that. It will go away.
3. Using any computer on the IthacaGenerator g wireless, type the IP address in any browser such as Chrome or Firefox. You should see the "Duet Web Control" interface.
Upload your gcode:
1. Click on the "Jobs" tab on the left.
2. Mount SD card 1 by choosing it from the green popup menu.
3. Click the dark blue "Upload G-code File(s)" button and upload your file. DO NOT do anything else until the upload is complete or the SD card could get corrupted.
IMPORTANT: If you did NOT use the Simplify3D slicer on our computer to create your G-code file, skip to the next section.
4. Click on your file in the list and click "Yes" when the prompt asks.
5. The printer will now go through a homing and leveling routine (if you used the Simplify3D slicer on our computer) and print your file.
For G-code not created with our Simplify3D profile:
Follow upload steps 1 through 3 above, then...
1. Click on the "Macros" tab on the left, choose "True Level" from the list, and run it.
2. After the machine is done, click on the "Jobs" tab on the left.
3. Click on your file in the list and click "Yes" when the prompt asks. Your file should now print.